Honeywell Versatilis Signal Scout - Epoxy Mounting

Figure 5-3: Screw-mount Adapter Mounting
Epoxy Mounting
Perform the below instructions for epoxy mounting on the target
structure:
Precaution: Do not handle until all safety precautions have been read
and understood. For more information, refer to the Safety Data Sheet
of the 3M™ Scotch-Weld™ DP810 duo-pak cartridge.
Prerequisite:
n
Ensure all the substrates are clean, dry, and free of paint, oxide
films, dust, mold release agents, and all other surface
contaminants.
n
The amount of surface preparation directly depends on the bond
strength and environmental resistance desired by the user.
n
Ensure a mix ratio of 1:1 by volume or 1:1 by weight using the 1:1
Shared Plunger in the Epoxy Applicator.
1. Insert the epoxy-based adhesive (3M™ Scotch-Weld™ DP810 duo-
pak cartridge) in the Epoxy Applicator (3M™ Scotch-Weld™ EPX
Manual Applicator).
Figure 5-4: Epoxy Applicator loaded with Epoxy-Based Adhesive
2. Remove the cap from the epoxy-based adhesive cartridge.
3. Dispense and discard a small amount of epoxy-based adhesive to
ensure an even ratio and free flow.
27
Chapter 5 - Setting up the Honeywell Versatilis Signal Scout