i. Uninstall the HVSS from the existing location (in the case of
moving to a new location). For more information on how to
uninstall, see Replacement of HVSS (steps 1 and 2).
ii. On the new location, mount the HVSS with the required
adapter on the target structure using recommended mounting
bracket (see the mounting instructions below).
iii. Calculate/Capture the GPS coordinates for the new location.
iv. Pair the HVSS using Honeywell Versatilis
TM
Connect App, and
map the new set of GPS coordinates to the HVSS.
B. Applying anti-seize lubricant on the threads of the adapter before
fitting it to the HVSS base helps to ensure the safe and easy
dissembling of the adapter with the HVSS base. Follow the below
guidelines while using anti-seize lubricant:
i. Before applying anti-seize, ensure that the threads are clean
and free from dirt, rust, or old lubricants. You can use a wire
brush, rag, or appropriate solvent to clean the threads
thoroughly. Make sure the threads are dry before applying the
anti-seize.
ii. Using a brush, applicator stick, or your fingers (if wearing
gloves), apply a thin, even coat of anti-seize to the threads. Be
careful not to over-apply, as excessive anti-seize can lead to
messy application and waste. The goal is to cover the threads
evenly without excess buildup.
iii. If necessary, use a brush or applicator to ensure the anti-seize
is evenly distributed across all the threads. This helps
maximize its effectiveness in preventing corrosion and seizing.
iv. Once the anti-seize is applied, proceed to assemble the HVSS /
HVSS - EH as usual. Be cautious not to cross-thread or
damage the threads during assembly.
v. After assembly, wipe away any excess anti-seize that may have
squeezed out during tightening. This helps maintain a clean
appearance and prevents the accumulation of dirt or debris.
Magnetic Mounting
Perform the below instructions for magnetic mounting on the target
structure:
23
Chapter 5 - Setting up the Honeywell Versatilis Signal Scout
To Next Page
Loading...
