Honeywell Versatilis Signal Scout - Adhesive Mounting

24
ATTENTION: Do not use bare hands while installation as the
magnet is powerful and can pinch the skin/ fingers if not
handled properly.
1. Screw-in the magnetic mount adapter into the threaded hole
provided on the base of the HVSS.
2. Firmly hold the base of the HVSS using a spanner (of size 41mm),
and tighten the adapter to the base using another spanner (of
size 32mm).
Ensure a Torque of 3.5 to 4 Nm is applied for tightening.
3. Attach the HVSS fitted with a magnetic mount adapter onto the
target structure (like beams, structure, frames, and etc) with the
help of magnetic pull force.
Figure 5-1: Magnetic Adapter Mounting
Adhesive Mounting
Perform the below instructions for adhesive mounting on the target
structure:
Chapter 5 - Setting up the Honeywell Versatilis Signal Scout