Honeywell Versatilis Signal Scout - Replacement of Honeywell Versatilis Signal Scout

Replacement of Honeywell Versatilis Signal
Scout
The modularized design of both variants, i.e., HVSS / HVSS - EH
allows you to disassemble the HVSS / HVSS - EH from the current
target structure and to mount it on some other target structure with
ease, or to replace the currently fitted mounting adapter with some
other adapter to suit the change in mounting surface.
Perform the below instructions to replace the HVSS / HVSS - EH:
1. Detach the HVSS / HVSS - EH from the target structure:
l
In case of screw-mount: Remove the M6 nut securing the HVSS
/ HVSS - EH onto the target structure.
l
In case of magnetic mount: Remove the HVSS / HVSS - EH
from the target structure manually.
l
In case of adhesive mount: Cut through the adhesive layer
(sticking the adapter to the target structure) using a blade.
l
In the case of adhesive mount (epoxy compatible): It is not
recommended to remove the adapter from the target structure
as the epoxy-based adhesive has very strong bonding to the
surface and any practice to separate it from the surface could
potentially result in damage to the respective surface.
2. In the case of screw-mount/magnetic mount/adhesive mount:
Firmly hold the base of the HVSS / HVSS - EH using a spanner (of
size 41mm), and unscrew the adapter from the base of the HVSS /
HVSS - EH using another spanner (of size 32mm) till it's
completely disassembled.
In the case of adhesive mount (epoxy compatible): Firmly hold the
adapter using spanner (of size 32mm), and unscrew the base of
the HVSS / HVSS - EH using another spanner (of size 41mm) till
it's completely disassembled.
3. Install the HVSS / HVSS - EH with the required mounting adapter.
For information on mounting procedure for HVSS / HVSS - EH
with various adapter types, see "Mounting Honeywell Versatilis
Signal Scout " on page22.
39
Chapter 8 - Maintenance