9
Table 2-2: Best Practices - DON'Ts
DON'Ts
Do not remove the HVSS enclosure without written
consent from Honeywell. The HVSS is packaged with
battery and sensitive electronics, that may be damaged
without proper care. Pay attention to don’ts when the
HVSS enclosure is removed:
l
Do not short-circuit.
l
Do not disassemble or change.
l
Do not expose to heat or fire.
Do not use bare hands while installing the magnetic
adapter on the target structure as the magnet is powerful
and can pinch the skin/fingers if not handled properly.
Do not mount the adhesive mount adapter on uneven,
rough, or curved surfaces as there is a potential risk of
falling down of the HVSS due to the lack of sufficient
bonding area.
Chapter 2 - Instructions and safety measures
To Next Page
Loading...
