Honeywell VFD CORE

CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
63-4528—04 126
• This parameter allows user to enter their password (which is pre-set in Pr.00-08) to unlock the parameter protection and to
make changes to the parameter.
• After you set up this parameter, make sure that you note its value for any future use.
• The purpose of hAVI1ng Pr.00-07 and Pr.00-08 is to prevent the personal misoperation.
• If you forget the password, clear the setting by input 9999 and press ENTER key, then input 9999 again and press Enter within
10 seconds. After decoding, all the settings will return to factory setting.
• When setting up a password all parameters read are 0, except parameter 00-08.
• This parameter is for you to set up a password to protect your parameter settings from unauthorized modifications. For the
very first set up, enter directly a password of your choice. Once you finish entering that password, the setting of the parameter
8 will be 1. Then the password protection is activated. If you want to modify any parameter, go to parameter 00-07, enter the
password that you set up here. If the right password is entered, then the parameter 00-08 will be 0 and you can modify any
parameter.
• Once you decode the parameter protection number at Parameter 00-07 and set the parameter to 0, the password protection
will be canceled. There will not be password protection when you re-start the VFD CORE.
• Password setting is permanently effective. If VFD need to modify any parameter, decode the parameter protection at
Parameter 00-07.
• How to re-start the parameter protection after the password is decode?
— Method01: Go to parameter 00-08, enter once a new password.
— Method02: Reboot the VFD CORE to restore the setting
— Method03: Input any value into Pr.00-07 (Do not enter the password).
a
00 - 07 Input Parameter Protection Password
Factory Setting: 0
Settings 0~65535
Display 0~4 (# of times of password attempts)
a
00 - 08 Set up a Parameter Protection Password
Factory Setting: 0
Settings 0~65535
Display 0: No password protection / password is entered correctly (Pr00-07)
1: Password has been set
M33605
PASSWORD SETTING
DISPLAYS “01” AFTER
CORRECT PASSWORD IS
ENTERED TO PR.00-08.
TO CHANGE PASSWORD:
KEY-IN 9999 AND PRESS “ENTER”,
THEN KEY-IN 9999 AGAIN WITHIN
10 SECONDS AND PRESS “ENTER”.
THIS RESETS ALL PARAMETERS
TO FACTORY SETTINGS.
3 ATTEMPTED PASSWORD INPUTS:
INCORRECT ENTRY #1, DISPLAYS: “01”
INCORRECT ENTRY #2, DISPLAYS: “02”
INCORRECT ENTRY #3, DISPLAYS: “Pcode” (BLINKING)
KEYPAD LOCKS AFTER 3 INCORRECT PASSWORD ATTEMPTS.
TO RE-ACTIVATE THE KEYPAD: REBOOT THE DRIVE AND
INPUT THE CORRECT PASSWORD.
PASSWORD FORGOTTEN PASSWORD INCORRECT
00-08 00-07 00-07