CHAPTER 10: DIGITAL KEYPAD
95 63-4528—04
Other display
When a fault occurs, the menu will display:
1. Press ENTER and start RESET. If still no response, please contact Honeywell Technical Support or return to the factory. To
view the fault DC BUS voltage, output current and output voltage, press “MENU”à“Fault Record”.
2. Press ENTER again, if the screen returns to main page, the fault is clear.
3. When fault or warning message appears, backlight LED will blinks until the fault or the warning is cleared.
Optional accessory for digital keypad: RJ45 Extension Lead
NOTES:
1. Keypad supports up to 4 main pages. If you download over 4 main pages, it will only support the first 4 downloaded main
pages.
2. By pressing keypads, you can only switch pages from pates. It doesn’t support entering words or images.
3. Downloading baud rate supports 9600 bps, 19200 bps and 38400 bps.
4. The VFD communication address to read and write are at 0x22xx
Main Page Refer to the full parameters in Chapter 12
PLC Enabled Refer to the full parameters in Chapter 12
Copy PLC Refer to the full parameters in Chapter 12
PC Link Refer to the full parameters in Chapter 12
Cable Description
Cable 7 RJ45 Extension Lead 7 feet
Cable 15 RJ45 Extension Lead 15 feet
Table 5. Definition of Communication Address
Address Read/Write Definition Description
2200h R b15~b0 Output current (A)
2201h R b15~b0 Counter Value ( c )
2202h R b15~b0 Actual Frequency (H)
2203h R b15~b0 DC-Bus Voltage (U)
2204h R b15~b0 Output Voltage(A)
2205h R b15~b0 Power Factor Angle (n)
2206h R b15~b0 Output Power(P)
2207h R b15~b0 Actual Motor Speed( r )
2208h R b15~b0 Output Torque (t)
2209h R b15~b0 PG Position (G)
220Ah R b15~b0 Feedback PV value ( b )
220Bh R b15~b0 AVI in percentage (1.)
Table 4. Main Menu Structure.
NOTE: This menu is accessed when the MENU button is pressed.
To Next Page
Loading...
Need help?
General
