39
To install the 5881ENHC RF receiver, perform the following steps:
Step Action
Mount the receiver, following the advisories stated previously.
NOTE: Must be mounted in a 5800Box Enclosure.
Set the DIP switches in the receiver for the address (01-07). See
Figure 3-18
Make sure the address setting is not being used by another device (keypad, relay module, etc.).
If installing a 5881ENHC,
install a flat-head screw (supplied) in the case tamper tab as shown in
Figure 3-
17. When the receiver is pried from the wall, the tamper tab will break off and remain on the wall. This will
activate a tamper switch in the receiver and cause generation of a tamper signal. Note that this signal will
also be generated when the receiver’s front cover is removed.
Connect the receiver’s wire harness to the keypad terminals (11, 12, 13 and 14). Plug the connector at the
other end of the harness into the receiver.
Refer to the Installation Instructions provided with the receiver for installations regarding antenna
mounting, etc.
Figure 3-17: Installing the 5881ENHC with Tamper Protection
Figure 3-18: 5881ENHC RF Receiver (cover removed)
To Next Page
Loading...
