5
List of Figures
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Figure 1-1: Isolating Fire Devices from Burglary Devices 16
Figure 3-1: Installing the Lock 21
Figure 3-2: Cabinet Attack Resistance Considerations 22
Figure 3-3: Commercial Fire Installation Considerations 23
Figure 3-4: Mounting the PC Board 24
Figure 3-5: Keypad Connections to Control Panel 25
Figure 3-6. ECP Isolator Wiring 25
Figure 3-7. Using a Supplementary Power Supply 26
Figure 3-8: Wiring Auxiliary Relay for Alarm Activation 30
Figure 3-9: Wiring Auxiliary Relay for Smoke Detector Reset 30
Figure 3-10: 2-Wire Smoke Detector on Zone 1 (for zone 2 use terminals 17 and 18) 33
Figure 3-11: 4-Wire Smoke Detectors 34
Figure 3-12: Wiring a Normally Closed Sensor Loop for Tamper Supervision 35
Figure 3-13: Wiring a Normally Open Sensor Loop for Tamper Supervision 35
Figure 3-14: Polling Loop Connections to the Control Panel 36
Figure 3-15: Polling Loop Connections Using One 4297 Extender Module 37
Figure 3-16: Polling Loop Connections Using Multiple Extender Modules 37
Figure 3-17: Installing the 5881ENHC with Tamper Protection 39
Figure 3-18: 5881ENHC RF Receiver (cover removed) 39
Figure 3-19: 4204 Relay Module 42
Figure 3-20: 4204CF Relay Module 42
Figure 3-21: Remote Keyswitch Wiring 44
Figure 3-22: Remote Keypad Sounder Wiring 44
Figure 3-23: Wiring Communicator to Keypad Terminals 46
Figure 3-24: Wiring the VistaKey 48
Figure 3-25: Connecting the Backup Batteries 56
VISTA-128FBPT/ VISTA-250FBPT Summary of Connections Diagram Inside Back Cover
To Next Page
Loading...
