Honeywell VISTA-128FBPT - Installing a Remote Keypad Sounder (for Commercial Burglary Use Only); Figure 3-21: Remote Keyswitch Wiring; Figure 3-22: Remote Keypad Sounder Wiring

44
Wiring for the Remote Keyswitch
To install the ADEMCO 4146 keyswitch, perform the following steps:
Step
Action
1
Connect the ADEMCO 4146 to the panel as shown in
Figure 3-21
.
2
If you are using the tamper, make sure it is connected to a zone.
Figure 3-21: Remote Keyswitch Wiring
Installing a Remote Keypad Sounder (For Commercial Burglary use only)
An optional Amseco PAL 328N Piezo Sounder can be used to duplicate the sounds produced by the keypad’s built-in
sounder. The remote sounder will duplicate all sounds (such as alarms, trouble beeps, etc.) except for the short beeps
associated with keypad key depression. One application of this feature would be to produce chime beeps at a distant
location from the keypads.
If used, program field 3
∗
20 must be set to “0” and field
∗
15 must be set to the desired partition number.
The remote sounder must be connected to the Output 5 on the J2 connector as shown in Figure 3-22.
Figure 3-22: Remote Keypad Sounder Wiring