212 Voyager XP User Guide
• Are enabled in the base or Access Point to which the scanner connects.
Is the barcode displayed but not entered into the application?
The barcode is displayed on the host device correctly, but you still have to press a
key to enter it (the Enter/Return key or the Tab key, for example).
• You need to program a suffix. Programming a suffix enables the scanner to
output the barcode data plus the key you need (such as “CR”) to enter the data
into your application. Refer to Prefix/Suffix Overview on page 93 for further
information.
The scanner won’t read your barcode at all.
• Scan the sample barcodes in the back of this manual. If the scanner reads the
sample barcodes, check that your barcode is readable.
Verify that your barcode symbology is enabled (see Chapter 7).
To Next Page
Loading...
Need help?
General