Voyager 1470/1472 User Guide 85
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scan-
ning. When the activation character is received, the scanner continues scanning
until either the Character Activation Timeout, the deactivation character is received
(see Deactivation Character), or a bar code is transmitted. Scan the following On
bar code to use character activation, then use Activation Character (following) to
select the character you will send from the host to start scanning. Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252), find the hex value that
represents the character you want to use to trigger scanning. Scan the following
bar code, then use the Programming Chart to read the alphanumeric combination
that represents that ASCII character. Scan Save to finish.
To Next Page
Loading...
