Honeywell Voyager XP 1470g Series - User Specified Intercharacter Delay; Interfunction Delay

Voyager 1470/1472 User Guide 97
To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0. Scan the Save bar code using the Programming Chart.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays, and the Save
bar code using the Programming Chart.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a
printable character to trigger the delay See ISO 2022/ISO 646 Character
Replacements on page A-220..
To remove this delay, scan the Delay Length bar code, and set the number of
delays to 0. Scan the Save bar code using the Programming Chart.
Interfunction Delay
An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each segment of the message string. Scan the
Interfunction Delay bar code below, then scan the number of 5ms delays, and the
Save bar code using the Programming Chart.
To remove this delay, scan the Interfunction Delay bar code, then set the number
of delays to 0. Scan the Save bar code using the Programming Chart.
Delay Length
Character to Trigger Delay
Interfunction Delays
Prefix Scanned Data Suffix
1 2345STX HT CR LF
Interfunction Delay