Honeywell Voyager XP 1470g Series - Application Work Group Selection; Reset the Factory Defaults: All Application Work Groups

62 Voyager 1470/1472 User Guide
Application Work Group Selection
This programming selection allows you to assign a scanner to a work group by
scanning the bar code below. You may then program the settings (e.g., beeper vol-
ume, prefix/suffix, data formatter) that your application requires. Default = Group 0.
Reset the Factory Defaults: All Application Work Groups
The following bar code defaults all of the work groups to the factory default set-
tings.
* Group 0
Group 1
Group 2
Group 3
Group 4
Group 5
Group 6
Factory Default Settings:
All Work Groups
PAPDFT&