48 Voyager 1470/1472 User Guide
response to an error. To change the number of error beeps, scan the bar code below
and then scan a digit (1-9) bar code and the Save bar code on the Programming
Chart. Default = 1.
Scanner Report
Scan the bar code below to generate a report for the connected scanners. The
report indicates the port, work group, scanner name, and address. To assign a
name to your scanner, refer to Menu Command Syntax, page 171.
Scanner Address
Scan the bar code below to determine the address of the scanner you are using.
Base or Access Point Address
Scan the bar code below to determine the address of the base or Access Point you
are using.
Scanner Modes
Your scanner is capable of working in single scanner mode, multiple scanner
mode, or with Bluetooth devices other than the charge base or Access Point.
Number of Base Error Beeps/LED Flashes
To Next Page
Loading...
