1 After you start a workout, swipe on the watch screen to check your real-time heart rate and
heart rate zone.
2 After completing your workout, you can check your average heart rate, maximum heart
rate, and heart rate zone on the workout results screen.
3 You can view graphs that show the changes in heart rate, maximum heart rate, and
average heart rate for each workout under Exercise records in the Health app.
• Your heart rate will not be displayed if you remove the watch from your wrist during the workout.
However, the watch will continue to search for your heart rate for a while. The measurement will
resume once you wear the watch again.
• Your watch can measure your heart rate when you have connected it to your phone and started a
workout using the Health app.
• Heart rate monitoring during swimming is supported on the HONOR MagicWatch 2.
Resting heart rate measurement
Resting heart rate refers to the heart rate when it is measured in a quiet and relaxed
environment when you are awake. It is a general indicator of cardiovascular health.
The best time to measure your resting heart rate is immediately after you have woken up in the
morning. Your actual resting heart rate may not be displayed or accurately measured if your
heart rate was measured at the wrong time.
To automatically measure your heart rate, enable Continuous heart rate monitoring in the
Health app.
If "--" is displayed as the resting heart rate reading, it indicates that your watch was unable to
measure your resting heart rate. In this case, ensure that you measure your resting heart rate in
a quiet and relaxed environment when you are awake. It is recommended that you measure your
resting heart rate immediately after you wake up in the morning for the most accurate result.
If you disable Continuous heart rate monitoring after checking your resting heart rate, the
resting heart rate displayed in the Health app will remain the same.
Heart rate warning
After you start a workout using your watch, your watch will vibrate to alert you that your heart
rate value has exceeded the upper limit for more than 10 seconds. To view and configure your
heart rate limit, perform the following:
Open the Health app, go to Me > Settings > Exercise heart rate settings > Workout heart
rate alerts and select your desired heart rate limit.
Health management
15
To Next Page
Loading...
