5 Commissioning
Rotary actuators 135 • M140 • M150 • M180
Operating instructions Version 2.0 - June 2012 19
5 Commissioning
Risk of injury from electric shock by live parts!
When the power supply is on there is a danger of electric shock due to live parts.
• Prior to commencing any work, ensure that the actuator is safely discon
nected
fro
m the power supply system.
• Secure against unauthorised restarting.
Risk of damage to device when adjusted manually
The actuator may sustain damage if the rotary actuator is not disconnected from
the power supply.
• Disconnect actuator from power supply
.
1 Ensure that the hood (200) is mounted.
2 Turn the rotary knob to (34) AUTO position.
3 Make sure that the motor is turned off in the end positions (limit position switch).
5.1 Setting a limit position switch on page 20
To Next Page
Loading...
