34
5. Other
PROBLEM POSSIBLE CAUSE REMEDY
[1] Icemaker will
not stop when
bin is filled with
ice.
a) Bin Control Switch 1. Completely disconnected
and dropped inside bin.
1. Place in position.
2. Detector broken. 2. Replace.
3. Detector out of position. 3. Place in position.
4. Defective reed switch. 4. Check for continuity and
replace.
5. Reed switch out of position. 5. Place in position.
6. Magnet disconnected from
detector.
6. Place in position.
b) Control Board 1. Defective. 1. See “II. C. Control Board
Check”.
[2] Abnormal
noise
a) Pump Motor 1. Bearings worn out. 1. Replace.
b) Fan Motor 1. Bearings worn out. 1. Replace.
2. Fan blade deformed. 2. Replace fan blade.
3. Fan blade does not move
freely.
3. Replace.
c) Compressor 1. Bearings worn out, or
cylinder valve broken.
1. Replace.
2. Mounting pad out of position
or loose hold-down bolt.
2. Reinstall.
d) Refrigerant Lines 1. Rub or touch lines or other
surfaces.
1. Reposition.
[3] Ice in Storage
Bin often
melts.
a) Bin Drain 1. Plugged. 1. Clean.
To Next Page
Loading...
Need help?
General