21
2. Bin Control Cleaning
Scale may build up on MBC. Scale can cause the actuator paddle and magnet to stick.
In this case, MBC should be cleaned.
WARNING
CHOKING HAZARD:
Ensure all components, fasteners, and thumbscrews are
securely in place after the icemaker is serviced. Make sure that none have fallen into
the ice storage bin.
1) Remove the air ¿ lter. Move the control switch to the “OFF” position, then unplug the
appliance.
2) Remove the top panel and the rear panel.
3) Disconnect the connector of the MBC lead (black) covered with a silicone hose and
remove the lead wire from the grommet.
4) Remove the water tank (see “IV. C. Water Tank”). The bin control switch is located
as shown below when viewed from the front.
Fig. 2
Separator Bin Control Switch
5) Pull down and remove the lead wire from the retainer on the right side of the bin
control switch. See Fig. 3.
6) Hold both sides of the bin control switch and pull it towards you.
To Next Page
Loading...
Need help?
General