35
III. Controls and Adjustments
* A HOSHIZAKI exclusive solid-state control is employed in crescent cubers.
* All models are pretested and factory-adjusted.
NOTICE
• Fragile, handle very carefully.
• The control board contains integrated circuits, which are susceptible to failure due
to static discharge. It is especially important to touch the metal part of the icemaker
when handling or replacing the control board.
• Do not touch the electronic devices on the control board or the back of the control
board.
• Do not change wiring and connections.
• Do not short out power supply to test for voltage.
• Always replace the whole control board assembly if it goes bad.
To Next Page
Loading...
Need help?
General