1
DES I G N IN S P IRAT I ON
*The mentioned manufacturers and product names are trademarks or registered trademarks of the respective owners. The trademarks were used merely to identify the sound character of this product.
Bluetooth Modeling Amplifier
This one-knob, extremely easy-to-use noise gate gets you
smooth, ripple-free noise tracking and keeps your signal
pristine.
Threshold: Controls the gate trigger level
This is a fully-functional noise gate with detailed control.
The individual Attack and Release controls play nice
with amps and other pedals.
Threshold: Controls the gate trigger level
Attack: Controls how soon the gate starts to process
the signal
Release: Controls the noise fade-out duration time
after the level drops below the threshold
The Holy Grail of compressor pedals is here.
Comprosso is based on the legendary Ross™
Compressor* pedal, which is unarguably the compressor
of compressors. We carefully recreated the sonic
character to get the same colorful, bouncy, natural
compression as the original pedal.
Sustain: Controls the compression amount
Output: Controls the effect output
This is a fully-functional compressor with lots of tonal
flexibility. A Tone knob is specially designed for further
tone shaping.
Threshold: Controls the compression trigger level
Ratio: Controls the amount of compression when the
compressor is triggered
Output: Controls the output volume/makeup amount
Attack: Controls how soon the compressor starts to
process the signal
Release: Controls how soon the compressor starts to
release the signal level back to normal after the level
drops below the threshold
Tone: Controls the effect tone
Blend: Controls the wet/dry signal ratio
This effect is based on the legendary MXR® M133
Micro Amp* pedal. Providing up to 20dB of gain, the
Micro Boost elevates your amp sound without changing
its tonal character.
Gain: Controls the gain amount
This boost is designed for modern Dentlemen and
metalheads who need huge gain buy not noisy artifacts.
A built-in noise gate reduces hum and keeps your palm
muting tight. Use the Low Cut knob to get your tone
where you want it.
Boost: Controls the boost amount
Gate: Controls the noise gate threshold
Low Cut: Cuts the low frequency signal
Based on the legendary FET-based belt clip preamp, this
boost is a clean volume machine. Use this pedal to get a
huge amount of gain without any distortion, tone sculpt
with the flexible 2-band EQ. Onboard you'll also find a
handy low cut filter for tone shaping and eliminating low
frequency feedback.
Volume: Controls the effect output
Bass/Treble: 2-band EQ that controls the effect tone
Low Cut: Switches the low cut filter (-6dB/oct
@200Hz) on/off
DYN
To Next Page
Loading...
