Hotone PULZE - 页 32

31
DES I G N IN S P IRAT I ON
*The mentioned manufacturers and product names are trademarks or registered trademarks of the respective owners. The trademarks were used merely to identify the sound character of this product.
Bluetooth Modeling Amplifier
FX Title
Description
Parameters & Ranges
FX 2
Delay
Amb Dly2
This model is a multi-tap delay that brings you
expanded sound spaciousness.
1, 2 stands for different tonal variations.
You can use Tap Tempo function to control the delay
time by turning on the Sync switch. When the Sync
switch is on, turn the Time/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Mix: Controls the wet/dry signal ratio
FB: Controls the amount of feedback
Time/Div: Controls the delay time/tap division value
Level: Controls the effect output
Mod: Controls the effect modulation amount
Tone: Controls the effect tone
Sync: Switches Tap Tempo sync on/off
Rev Dly
This is a delay model that reverses the original sound.
It's like we recorded your sound with a tape recorder
and then played it backwards. That's where this model
goes.
You can use Tap Tempo function to control the delay
time by turning on the Sync switch. When the Sync
switch is on, turn the Time/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Mix: Controls the wet/dry signal ratio
FB: Controls the amount of feedback
Time/Div: Controls the delay time/tap division value
Level: Controls the effect output
Sync: Switches Tap Tempo sync on/off
P-Pong
This model is a ping-pong delay producing stereo
feedback that bounces back and forth between the left
and right channels.
You can use Tap Tempo function to control the delay
time by turning on the Sync switch. When the Sync
switch is on, turn the Time/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Mix: Controls the wet/dry signal ratio
FB: Controls the amount of feedback
Time/Div: Controls the delay time/tap division value of
left channel
Time R%: Controls the delay time of right channel (time
ratio of left channel)
Spread: Controls the effect stereo width
Level: Controls the effect output
Sync: Switches Tap Tempo sync on/off
LoFi Dly
This delay model comes with a bitcrusher that affects
only the delay repeats, producing lo-fi'd feedback.
You can use Tap Tempo function to control the delay
time by turning on the Sync switch. When the Sync
switch is on, turn the Time/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Mix: Controls the wet/dry signal ratio
FB: Controls the amount of feedback
Time/Div: Controls the delay time/tap division value
Crush: Controls the effect downsampling rate
Bit: Controls the effect bit depth reducing amount
Level: Controls the effect output
Sync: Switches Tap Tempo sync on/off
Reverb
Room
This reverb model recreates the spaciousness of a
room.
Mix: Controls the wet/dry signal ratio
Pre Dly: Controls the amount of time between the dry
signal and the audible onset of early reflections and the
reverb tail
Decay: Controls the duration of reverb time
Low Damp/Hi Damp: Dampens the effect low/high
frequency amount
Mod: Controls the effect modulation amount
FX 2