8
DES I G N IN S P IRAT I ON
*The mentioned manufacturers and product names are trademarks or registered trademarks of the respective owners. The trademarks were used merely to identify the sound character of this product.
Bluetooth Modeling Amplifier
This model is based on the legendary and extremely
rare 1970s Electro-Harmonix® Small Stone phase
shifter* pedal. This original is one of the best analog
phaser sounds in the history of music and can be heard
on countless rock recordings.
You can use Tap Tempo function to control the effect
speed by turning on the Sync switch. When the Sync
switch is on, turn the Rate/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Color: Selects the phaser sound character from warm to
sharp
Rate/Div: Controls the effect speed/tap division value
Sync: Switches Tap Tempo sync on/off
This model delivers a lush rotating effect that
simulates 1960s rotary speakers. Based on the Voodoo
Lab® Micro Vibe*, it gives you the pure, "psychedelic"
vibe-y taste that guitar heroes like Hendrix and Gilmour
loved.
You can use Tap Tempo function to control the effect
speed by turning on the Sync switch. When the Sync
switch is on, turn the Rate/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Depth: Controls the effect depth
Rate/Div: Controls the effect speed/tap division value
Sync: Switches Tap Tempo sync on/off
This model is based on the legendary vintage Shin-ei®
Uni-Vibe®* pedal. The Uni-Vibe®* was designed to
simulate the sound of a rotary speaker, but the "failed"
attempt has been embraced as one of the most iconic
effects in rock 'n' roll history. Kick it on and feel the
legendary psycho sound of the Revolver!
You can use Tap Tempo function to control the effect
speed by turning on the Sync switch. When the Sync
switch is on, turn the Rate/Div knob to set a proper tap
divide value. The default value is 1/4 (no division).
Depth: Controls the effect depth
Rate/Div: Controls the effect speed/tap division value
Volume: Controls the effect output
Mode: Select from 2 different vibe modes: Chorus and
Vibrato
Sync: Switches Tap Tempo sync on/off
This model is a rotary speaker simulator with detailed
control, bringing you the legendary tone adapted by
lots of rock legends.
You can use Tap Tempo function to control the effect
speed by turning on the Sync switch. When the Sync
switch is on, turn the B. /H. Rate/Div knobs to set a
proper tap divide value. The default value is 1/4 (no
division).
Mix: Controls the wet/dry signal ratio
B. Rate/Div: Controls the bass rotating speed/tap division
value
H. Rate/Div: Controls the horn rotating speed/tap division
value
Balance: Controls the bass/horn sound balance
Tone: Controls the effect tone
Bass/Horn Sync: Switches Tap Tempo sync on/off
PRE
To Next Page
Loading...
