HOT SPRING
®
ON/READY INDICATOR LIGHT
The Hot Spring logo on the front of the spa illuminates a blue and green color. These colors
indicate the power and ready status of the spa without having to open the cover and look
at the control panel. The green color is equivalent to the READY Indicator described in the
previous section, and the blue color is equivalent to the POWER Indicator described above.
If blue or green lights are flashing refer to Toubleshooting section of Owner's Manual.
HOME SCREEN
On the Home screen you will notice the temperature displayed in the center of the screen. This
temperature is the actual temperature of the spa water. If the READY icon is lit and solid on the
control panel, then the actual spa temperature is within 2°F (1°C) of the set temperature. The
corner soft button functions are as follows:
ALL OFF
This feature will shut jets and lights off immediately, while saving the last active jets and lights
settings.
MEMORY
This feature will recall the last active setting for jets and lights prior to pressing the All Off button.
NOTE: If the jet pump will not engage, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on both the main and auxiliary
control panels.
CLEAN
Provided as a convenient timer for water maintenance, activates the jet pump on high for a ten minute period. The blue Jet icon will
flash to indicate the jet pump is engaged and in the clean cycle. Next you may add properly measured spa water chemicals into the filter
compartment. The jet pump and clean icon will automatically shut off after ten minutes.
NOTE: Some soft key functions will only be illustrated if the accessory has been installed.
MEDIA
This feature will take you to the Media sub menu (accessory feature).
TEMPERATURE CONTROL
The set temperature range is from 80°F to 104°F (26°C to 40°C). (The water temperature of any spa
may rise or lower slightly depending on the current use and condition of your spa and on outside
temperatures.)
The set temperature of the spa water will automatically be 100°F (38°C) the first time that power is
applied. This is the setting programmed at the factory. After the spa has been set up and used, the
last temperature value set by the user will be stored in memory. If power is disconnected from the
spa, it will automatically revert to the last set temperature when power is reapplied.
To display the set temperature of the spa, press the
OPTIONS hard button followed by the TEMPERATURE soft button. The
temperature screen will then be displayed. This screen will automatically revert to Home screen after 45 seconds of non-use.
To increase the set temperature of the spa water, press the
TEMP ▲button.Eachtimethebuttonispressed,thesettemperature
display will increment by one degree. If the button is held down, the set temperature display will increase by one degree every half-second.
To decrease the set temperature of the spa water, press the
TEMP ▼button.Eachtimethebuttonispressed,thesettemperature
display will decrement by one degree. If the button is held down, the set temperature display will decrease by one degree every half-
second.
If the set temperature value will not change, check the
TEMP LOCK and SPA LOCK features. When either of these features is activated,
the temperature control is disabled.
The temperature may also be displayed in Fahrenheit or Celsius. Press the soft button next to the °F/°C description to change.
LOCKING FEATURES
The two locking features, TEMPERATURE LOCK and SPA LOCK, are activated from the main control panel. Once activated, a lock will
remain active until the specific button combination is applied to disable the lock. Even if power is disconnected from the spa and soon
thereafter reapplied (such as in a power outage) the lock will remain in place.
Page 31
Control Panel Operations
Green indicator - water is ready, within
2°F of set temperature
Blue indicator - Power to spa is on
To Next Page
Loading...
Need help?
General
