Page 32
TEMPERATURE LOCK
The TEMPERATURE LOCK feature deactivates the temperature control function on the main
control panel. All other functions on the main and auxiliary control panels will operate normally.
TEMPERATURE LOCK is most often used by people who do not want others to tamper with or
change the set temperature of the spa water.
To activate the
TEMPERATURE LOCK, press the OPTIONS hard button followed by the
TEMPERATURE soft button and finally press the soft button TEMP LOCK OFF to change the
screen to TEMP LOCK ON.
NOTE: The red Spa lock icon will be lit during a temperature lock condition.
When the
TEMPERATURE LOCK is activated, the JETS, LIGHT, and CLEAN buttons will operate normally, and the temperature setting
can be viewed but can NOT be changed.
To deactivate the
TEMPERATURE LOCK, press the OPTIONS hard button followed by the TEMPERATURE soft button followed by the
TEMP LOCK ON soft button to change the screen to TEMP LOCK OFF, this will also turn the Spa lock icon off.
SPA LOCK
The SPA LOCK feature disables all of the functions on the main and auxiliary control panels. It is
generally used to prevent unwanted use of the spa. The control panel will not respond to any hard or soft
buttons when in spa lock mode.
To activate the
SPA LOCK, press the OPTIONS hard button followed by the SET-UP soft button. The
screen to the left will then be displayed.
To activate the
SPA LOCK, press the soft button for SPA LOCK.
NOTE: The Spa lock icon will be lit during a spa lock condition.
To deactivate the SPA LOCK, press and hold both the OPTIONS hard button and the LIGHTS hard button for 3 seconds.
LOCK OVERRIDE
The Lock Override feature is for spa users who normally keep the set temperature locked. Should the user wish to lock all spa controls
temporarily, the spa lock can be activated over an already activated temperature lock. Then, when the spa lock is removed, the
temperature lock will remain on, to prevent unwanted tampering with the set temperature.
JETS CONTROL
The JETS hard button activates the jet pump(s). When the JETS hard button is pressed, the jets menu
will display on the control panel as seen on the right with Jet 1 in the High position (Vanguard
®
&
Sovereign
®
models) or Jet 2 Low position (Vista
®
, Grandee
®
, Envoy
®
and Aria™ models), the blue
Jet Pump icon will also light up. Press any of the soft keys to change the jet functions between high,
low (when available) speed, and off.
The Jet pump icon will remain lit until the button is pressed to turn off the jet pump(s), or after two
hours of continuous operation when the pump(s) is automatically shut off by the control system.
If the jet pump will not engage, make sure
SPA LOCK is deactivated. SPA LOCK disables the controls
on both the main and auxiliary control panels.
You may also run through the entire jet pump cycle by only using the JETS hard button as follows:
VISTA
®
, GRANDEE
®
, ENVOY
®
& ARIA
®
1st Press = Jet pump 2 on Low 2nd Press = Jet pump 2 on High 3rd Press = Both jet pumps on high speed
4th Press = Jet pump 2 on Low,
Jet pump 1 on high
5th Press = Jet pump 1 on High 6th Press = All pumps off
VANGUARD
®
1st press = jet pump 1 on High 2nd press = jet pump 1 & 2 on High 3rd press = jet pump 2 on High 4th press = jet pumps OFF
SOVEREIGN
®
,
PRODIGY
®
& JETSETTER
®
1st press = jet pump on High 2nd press = jet pump OFF
LIGHT CONTROL
All Hot Spring
®
spas are equipped with Luminescence
®
Four-Zone Multi-Color lighting.
Control Panel Operations
To Next Page
Loading...
Need help?
General
