INSTALLATION MANUAL 9
UNPACKING AND INSTALATION
Before you begin the installation, check the oven for any transport damages. If there are
signs of damage, inform your supplier and freight company immediately.
UNPACKING AND INSTALLING THE OVEN
We recommend using a pallet trolley for lifting the oven. Some oven types must only be
lifted with a pallet trolley. If this is not possible, the right liftin tools are mandatory.
To Unpack and Move the Oven
1. Leave the oven packaging while moving the oven. Use a pallet trolley to move the
oven to the place in desired installation position.
2. Insert the forks under the lower cross tube of the stand and place wooden blocks
between the cross tube and the pallet trolley. You achieve the best possible
balance by introducing the forks from the front of the oven or from the motor side.
Ensure sucient clearance under the oven when you moving it from the pallet.
3. When you have placed the oven in position, you can remove the oven packaging.
However, leave the foil that covers the surfaces until you have installed the oven.
The foil protects the surfaces from sharp objects.
4. Remove the packaging from the racks inside the oven.
Disposal of Packaging Material
The packaging material must be destroyed in compliance with local rules and regulations.
You can request detailed information about the composition of the packaging material
from the HOUNÖ customer center.
Do not lift the oven from the left side.
To Next Page
Loading...
