42 INSTALLATION MANUAL
Gas Hose Restraint
If the appliance is mounted on casters, a commercial flexible connector with a minimum of
3/4” (1.9 cm) inside diameter must be used along with a quick connect device.
A restraint must be used to limit the movement of the appliance so that no strain is placed
upon the flexible connector. The restraint should be fastened to the base frame of the oven
as close to the flexible connector as possible. It should be short enough to prevent any strain
on the connector. With the restraint fully stretched the connector should be easy to install
and quick connect.
The restraint (ie: heavy gauge cable) should be attached without damaging the building. DO
NOT use the gas piping or electrical conduit for the attachment of the permanent end of the
restraint! Use anchor bolts in concrete or cement block. On wooden walls, drive hi test wood
lag screws into the studs of the wall.
WARNING!
If the restraint is disconnected for any reason it must be recon-
nected when the appliance is returned to its original position.
The installation of the ventilations must be carried out in compliance
with local rules and regulations.
To Next Page
Loading...
