RMODe
Command :RMODe {SINGle|REPetitive}
The RMODe command specifies the run mode for the selected module (or
Intermodule). If the selected module is in the intermodule configuration,
then the intermodule run mode will be set by this command.
After specifying the run mode, use the STARt command to start the acquisition.
Example OUTPUT XXX;":RMODE SINGLE"
Query :RMODe?
The query returns the current setting.
Returned Format
[:RMODe] {SINGle|REPetitive}<NL>
Example OUTPUT XXX;":RMODE?"
Mainframe Commands
RMODe
10–19
To Next Page
Loading...
