Table 14-1 TGTctrl Parameter Values
Parameter Value
N An integer, 0 through 7, indicating signal
bits An integer, 0 though 255
state An integer, 0 through 7
name A string of up to 14 characters
:TGTctrl
Selector :TGTctrl
This command does not obey the truncation rule.
The TGTctrl selector specifies target control as the subsystem the commands
or queries following will refer to. Because the TGTctrl command is a root
level command, it will normally appear as the first element of a compound
header.
Example OUTPUT XXX;":TGTCTRL:ALL4?"
TGTctrl Subsystem
:TGTctrl
14–5
To Next Page
Loading...
