HP 1810-8G User Manual

As shown in the example configuration in Figure 22, flow control is enabled globally, which would
enable flow control on all the ports in the switch.
Figure 22 Flow Control Page
Table 19 Flow Control Fields
DescriptionField
Enable flow control on the switch. Clear to disable the feature.Enable Flow Control
Click Apply to save any changes for the current boot session; the changes take effect immediately.
Green Features
The switch software allows the user to enable or disable port, cable, and LED energy saving features
that consume less power than the normal high-performance mode.
To display the Green Features configuration page, click Switching > Green Features in the navigation
pane.
Figure 23 Green Features
Table 20 Get Connected Fields
DescriptionField
Port Energy Saving Configuration
Enable power save mode when there is no link. This feature is disabled by
default.
Auto Port Power-Down
EEE (Energy Efficient Ethernet) is designed to save power by turning off network
ports that are not passing traffic. EEE works for ports in auto-negotiation mode,
Low-Traffic Idle (EEE)
where the port is negotiated to either 100 Mbps Full Duplex or 1 Gbps (1000
Mbps) Full Duplex. Valid values are Disable and Enable. This feature is disabled
by default.
34 Switching Pages

HP 1810-8G Specifications

General

Switching Capacity	16 Gbps
Throughput	11.9 Mpps
MAC Address Table Size	8000 entries
Jumbo Frame Support	Yes
PoE	No
Weight	2.2 lb (1 kg)
Ports	8 x 10/100/1000
Form Factor	Desktop, Rack-mountable
Management	Web-based
Power Supply	External
Operating Temperature	0°C to 40°C
Operating Humidity	15% to 95% non-condensing