HP 3325B - Page 117

Index
A
Accessories 3-5
Amplitude cdibration key 1 - 3 ,1-32
Amplitude key 1-17
Amplitudelimitsofacfunctions 1-17
Amplitude modulation 1-28
input connector 1 -3
input impedance 1 -29
Ampli^de vs. function 1-10
Arbitrary waveforms 1 -30
Arrow keys 1-15
Assign zero phase key 1-20
Attention (ATN) bus line 2-4
Auxiliary output connector 1 -3
B
Bandwidth vs. function 1 - 1 6
Bandwidth, linear sweep 1-25
Baud rate 1 -35, 2-14
Bus commands (HP-IB) 2-7
Bus management lines (HP-IB) 2-3
c
Calibration 1-32
Cancelling sweeps 1-24
Oianging sweep bandwidth 1-24
Changing the bus address 2-7
Circuit breaker reset 1 -3
Clear command 2-7
Clear discrete key 1 -26
Oear display 1-13
Clear key 1-13
Clear lockout 2-8
Clear memory 1-31
dear all memory 1-4
discrete sweep table 1 -3
Command Mode 2-4, 2-7
Command syntax 2-17
Compatibility 2-31,2-69,2-71.3-4
Compatibility mode 1-4,2-13
Connectors
amplitude modulation input 1-3.1-28
auxiliary ou^ut 1 -3,1 -41
external reference input 1-3
fast sync output 1-3
HP-IB 1-34
msun signal 1-8
main signal output 1-41
main signal output (front panel) 1 -3
main signal output (rear panel) 1 -3
marker output 1 -3.1 -37
modulation source 1-29
modulation source output 1-3
phase modulation input 1-3,1-29
reference output 1-3
RS-232 1-35
synchronized output 1-3
10 MHz oven 1-3,1-42
X-drive 1-3,1-37-1-38
Z-bla^k 1-3,1-38
Z-blank ou^ut 1 -37
Continuous
discrete sweeps 1-27
indicator 1 -25
linear sweeps 1 -25
sweeps 1-21.1-24,1-37
Converting units 1-17
D
Data entry 1-12
Data keys 1-2,1-12
Data Mode 2-4, 2-7
Data transfer rate 2-2
DC offset 1-11
key 1-17
limits 1-18
Default address 2-7
Description of the HP-IB 2-2
Disabling modulation 1-30
Discrete sweep key 1-27
Discrete sweeps 1 -21 ,1 -26.1 -37
Ksptay 1-2
clear 1-13
dc offset 1 -11
indicators 1-14
parameters 1-14
units 1-14
Displaying the bus address 2-6
Distortion 1-11
causes 1-3
E
Editing data entries 1-13
Bid or Identify (EOl) 2-4
Enhancements 1 -25, 2-13, 2-31
Bitering discrete sweep parameters 1 -26
Entiykeys 1-2
EOCS character 2-20
Error messages 1-13,2-67
Example Programs 2-72
External frequency reference 1 -42
External reference indicator 1-3
External reference input connector 1 -3