HP 3325B User Manual

Operation and Reference
Table 1-4. Error Messages (Cont’d)
Error Code
Description
752
Key ignored front-panel key pressed while the HP 3325B is in local
lockout
753
Feature disabled in compatibility mode
754
Attempt to recall a memory register that has not been stored since
power up
755
Amplitude modulation not allowed on selected function
756
Modulation source arbitrary waveform memory register Is empty
757
Too many modulation source arbitrary waveform points
758
Firmware (program) failure
800
A remote HP-IB or RS-232 command has a syntax error
801
Illegal digit for selection item
802
Illegal binary data block header
803
Illegal string, string overflow
810
RS-232 overrun - characters lost
811
RS-232 parity error
812
RS-232 frame error
900
Option not installed
-CAL-
Calibration in progress
PASS
A self test is successful
FAIL
A self test is unsuccessful - refer the HP 3325B to qualified service
personnel for repair
Viewing Setup Parameters
Pressing a front-panel key which accepts data entry (such as the [Freq] or [Amptd] key)
displays the current value of a setup parameter. Table 1-3 lists the front-panel keys which
accept data entries. Pressing one of these keys does not alter the current setup values.
The units of the displayed parameter are indicated by an illuminated indicator at the right of
the display. The indicators at the left of the display indicate whether the display value is
associated with the Main Signal or the Modulation Source.
1-14

HP 3325B Specifications

General

Brand	HP
Model	3325B
Category	Portable Generator
Language	English