HP 3325B User Manual

Operation and Reference
The value entered with the Data keys may he edited during data entry with
the left-arrow key in the Modify key group. Each time the left-arrow key is
pressed, the least-significant digit or decimal point is removed from the
display. After the incorrect digits are removed from the display value, data
entry can continue.
Clear Display
! ^ Pressing the [Clear] key (in the left column of the Data key group) clears
I Clear I the display to zero. This key is useful when an error is made while entering
'- data.
o
0
Error Messages
If an attempt is made to enter or modify operating parameters beyond the HP 3325B
capabilities, the new input is ignored and an error message and code is displayed. Table 1-4
lists the error messages and explanations of the errors.
Table 1-4. Error Messages
Error Code
Description
100
The value entered for the selected parameter exceeds the valid limits
200
The units key selected is improper for the selected parameter
201
The units key selected is improper for the selected parameter with high
voltage option
300
The frequency entered is too high for the waveform function selected
400
The sweep time entered is too large for the frequency span
(sweep span is too small)
401
The sweep time is too small for the frequency span.
500
Anpiitude and dc offset values are incompatible
501
The dc offset is too large for amplitude
502
The amplitude is too large for the dc offset
503
Amplitude is too small
600
Sweep frequency improper
601
Sweep frequency too large for function
602
Sweep bandwidth too small
603
Log sweep start frequency too small
604
Log sweep stop frequency less than start frequency
605
Discrete sweep segment is empty
700
Unknown command
701
Illegal query
751
Key ignored front-panel key pressed while the HP 332SB is in remote
(press LOCAL key)
1-13

HP 3325B Specifications

General

Brand	HP
Model	3325B
Category	Portable Generator
Language	English