HP 3325B - Page 82

HP 3325B Remote Operation Command Set
MS; Status Byte Mask Command
The MS command is used to set the status byte mask. Four lists in the status byte are
capable of causing a service request (SRQ) when they are enabled (unmasked). They may be
enabled or masked in any combination as defined in table 2-34. The ESTB command
accomplishes the same thing using decimal numbers instead of alphabetic characters.
Instrument Power-on value: @ (no bits enabled).
Instrument Preset, HP-IB Clear value: not changed.
Command Availability
MS
HP 3325B yS
HP 3325A Yes
Table 2-34. Status Byte Mask Characters
“character”
FAIL
Status Bits
START STOP
ERR
@ Mask
Mask
Mask
Mask
A
Mask
Mask
Mask
ENABLE
B
Mask
Mask
ENABLE
Mask
C
Mask
Mask
ENABLE
ENABLE
D
Mask
ENABLE
Mask
Mask
E
Mask
ENABLE
Mask
ENABLE
F
Mask
ENABLE
ENABLE Mask
G
Mask
ENABLE
ENABLE
ENABLE
H
ENABLE
Mask
Mask
Mask
!
ENABLE
Mask
Mask
ENABLE
J
ENABLE
Mask
ENABLE
Mask
K
ENABLE
Mask
ENABLE
ENABLE
L
ENABLE
ENABLE
Mask
Mask
M
ENABLE
ENABLE
Mask
ENABLE
N
ENABLE
ENABLE
ENABLE
Mask
0
ENABLE
ENABLE
ENABLE
ENABLE
2-50