Storing Data into Variables 3-3
To recall the value stored in a variable, use the Recall command. The display of this
command differs slightly from RPN to ALG mode, as the following example
illustrates.
Example:
In this example, we recall the value of 1.75 that we stored in the variable G in the
last example. This example assumes the HP 35s is still in ALG mode at the start.
In ALG mode, Recall can be used to paste a variable into an expression in the
command line. Suppose we wish to evaluate 15-2×G, with G=1.75 from above.
We now proceed to switch to RPN mode and recall the value of G.
Keys: Display: Description:
_ Avogadro's number.
A
_“” prompts for variable.
Stores a copy of Avogadro's number
in A. This also terminates digit entry .
_ Clears the number in the display.
A..Z The A..Z annunciator Turns on
A
Copies Avogadro's number from A
the display.
Keys: Display: Description:
G
Pressing simply activates A…Z
mode; no command is pasted into
line 1.
Keys: Display: Description:
G
To Next Page
Loading...
