HP 425 User Manual

6
Figure 5 Drilling holes in the wall
2. Insert a wall anchor into each mounting hole, and tap the wall anchor with a rubber hammer until
it is flush with the wall surface as shown in Figure 6.
Figure 6 Inserting a wall anchor
3. Align the holes in the wall-mounting bracket with the anchors and insert screws through the
installation holes into the wall anchors as shown in Figure 7.
4. Adjust the position of the wall-mount
ing bracket and tighten the screws.
40 mm
86 mm

HP 425 Specifications

General

Device Type	Wireless Access Point
Product Name	HP 425
Maximum Data Rate	300 Mbps
Ethernet Ports	1
Wireless Protocol	802.11n
Frequency Band	2.4 GHz
Antennas	2 internal antennas
Power Source	Power over Ethernet (PoE) or External Power Adapter
Security Features	WPA, WPA2, WEP, 802.1X