HP 5920

125
Ste
p
Command Remarks
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name operation-tag
By default, no NQA operation is
created.
3. Specify the DNS type and
enter its view.
type dns N/A
4. Specify the IP address of the
DNS server as the destination
address of DNS packets.
destination ip ip-address
By default, no destination IP
address is specified.
5. Specify the domain name
that needs to be translated.
resolve-target domain-name
By default, no domain name is
specified.
Configuring the FTP operation
The FTP operation measures the time for the NQA client to transfer a file to or download a file from an
FTP server.
Follow these guidelines when you configure the FTP operation:
• When you perform the put operation with the filename command configured, make sure the file
exists on the NQA client.
• If you get a file from the FTP server, make sure the file specified in the URL exists on the FTP server.
• The NQA client does not save the file obtained from the FTP server.
• Use a small file for the FTP operation. A big file might result in transfer failure because of timeout,
or might affect other services for occupying much network bandwidth.
To configure the FTP operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is created.
3. Specify the FTP type and
enter its view.
type ftp N/A
4. Specify the URL of the
destination FTP server.
url url
Enter URL in one of the following formats:
• ftp://host/filename.
• ftp://host:port/filename.
When you perform the get operation, the
file name is required.
5. (Optional.) Specify the
source IP address of FTP
request packets.
source ip ip-address
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no FTP
requests can be sent out.