HP 5920

252
</rpc>
Verifying the configuration
After receiving the get-config request, the device returns a response in the following format if the
operation is successful:
<?xml version="1.0"?>
<rpc-reply message-id="100" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<data>
All data matching the specified filter
</data>
</rpc-reply>
Performing the edit-config operation
The edit-config operation supports the following operation attributes: merge, create, replace, remove,
delete, default-operation, error-option, and test-option. For more information about these attributes, see
"Appendix A Supported NETCONF operations."
# C
o
py the following text to perform the <edit-config> operation:
<?xml version="1.0"?>
<rpc message-id="100" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<edit-config>
<target><running></running></target>
<error-option>
Default operation when an error occurs
</error-option>
<config>
<top xmlns="http://www.hp.com/netconf/config:1.0">
Specify the module name, submodule name, table name, and column name
</top>
</config>
</edit-config>
</rpc>
After receiving the edit-config request, the device returns a response in the following format if the
operation is successful:
<?xml version="1.0">
<rpc-reply message-id="100" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
# Perform the get operation to verify that the current value of the parameter is the same as the value
specified through the edit-config operation. (Details not shown.)
All-module configuration data retrieval example
Network requirements
Retrieve configuration data for all modules.