14
To install a cable management bracket:
1. Unpack the cable management brackets.
2. Attach the cable management bracket to the chassis, and align the screws with the screw holes in
the chassis, as shown in Figure 10.
3. Fasten the s
crews.
Figure 10 Attaching cable management brackets on an HP 7506-V
(1) Attach the cable mana
ement bracket to the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for fixin
ement bracket to the chassis
ement bracket without a tray (installed at the upper part of the chassis)
(5) Cable management bracket with a tray (installed at the lower part of the chassis)
Attaching the cable management brackets on other models
For the models except the 7506-V, install the cable management bracket on the left mounting bracket, as
shown in Figure 11. T
he switch is supplied with two mounting brackets, and the one with the cable
management bracket screw holes is the left mounting bracket.
1
2
3
3
2
1
5
4
To Next Page
Loading...
