I
-
I
-
Instrument State Keys
(GiiL)
Pressing this key restores the state of the instrument from a register
(l-9).
When this key is pressed, the prompt message in the right-hand display is
REC:HLL
Reg =
??.
When a digit
<n>
is pressed on the entry keyboard, the
display shows
REC:HLL
Req
=
<n>
and the instrument state is recalled from
that register. Note that a units key (i.e.
(j-1)
does not need to be
pushed. Successive numbers can be pushed to recall instrument state from
multiple registers. Entry key
@J
has no effect.
*RCL
<n>
Associated SCPI Commands
Restores the state of the instrument
from register
-cn>.
RC
<n>
Associated 8350 Commands
Restores the state of the instrument
from register
00.
SPECIAL
When this function is selected (by pressing [SHIFT)
[?ZZXLiI])
the special
functions menu is accessed.
When this key is pressed, the last-used special function is displayed in the
form <number> <function>. (If no special functions have been accessed
since the instrument was last preset, the last-used special function will
default to 1
13h::F
HUTI:I.)
The
@
a
keys or the front panel knob can be
used to scroll through the list of available functions in the menu; or the
number of the desired special function can be entered from the keypad.
When the desired special function is displayed, pressing the
CHz/s/ENTER)
key causes the function to become the active parameter displayed in the
MARKER/SWEEP/STATUS display. Pressing the
(FJ
key returns the last
menu item in the form <number> <function>.
8-8
To Next Page
Loading...
General