I
-
Special Functions
13-PWR
This function allows you to set the power meter
HP-E!
address to the desired
METER
AD
setting. The range of acceptable values is from 0 to 30.
NOTE
The value set at the factory is 13. If you change this value, it will not be altered, or reset to 13, by
presetting or cycling the line power on the instrument.
Associated SCPI Commands
SYSTem:COMMunicate:PMETer:ADDRess
Sets the HP-B address to used for the
power meter during sweeper
caibration
routines.
15-18
To Next Page
Loading...