I
-
I
-
Frequency Keys
MPl
MPO
Associated 8350 Commands
Turns
marker sweep an.
Turns marker sweep
off
IUII=START
This function copies the values of the markers Ml and
M2
to the START
M2=STOP
and STOP frequencies respectively. The new frequencies are then shown in
the FREQUENCY displays. Markers Ml and
M2
are turned
oli
if they were
previously off. Also, if
Ml-M2
Sweep mode is on, it will be automatically
turned off when this function is selected.
NOTE
If the value of Ml is greater than the value of
M2,
the values will be interchanged when they are put
into the start and stop frequencies. However, the values stored in Ml and
M2
will not change.
Associated SCPI Commands
SWEep:MARKer:XFER
Transfers values of
Ml
and
I%??
to
the start and stop
frequencies.
SHMP
Associated 8350 Commands
Transfers values of Ml and
M.?
to
the start and stop
frequencbs.
11-13
To Next Page
Loading...
General