I
-
Special Functions
l This function only works in CW or manual sweep mode.
f
This special function only operates with sweepers that have Option
IEI.
$ For instruments without Option
lE5.
#
For instruments with Option
lE5.
“* This is the value set when shipped from the factory. If changed, it will not be altered by presetting or cycling the line
power on the instrument.
ff’
The selected value will be different then the displayed value if you have a millimeter source module connected to your
sweeper. See “FM
SENSITVTY’
later in this chapter.
$$
This is the value set when shipped from the factory. Changes made via this special function will be retained through en
instrument preset. Changes made via this special function may or may not be retained through a cycling of the line power,
depending on how the rear panel language switch is set. Refer to the chapter entitled “front/Rear Panel” in this manual for
switch setting information.
##These special functions provide access to the service related function menus and are documented in the HP 83751AB and
HP
8375ZAB
Synrhes&d
Sweepers
Sewi&?
Guide. These areas are intended only for use by service personnel.
To Next Page
Loading...
General