HP 83751A - Page 21

I
-
I
-
Figures
l-l. The UNLEV Annunciator Location ............. l-7
l-2. Connections for Checking Output Power ..........
l-8
2-l. ALC Circuit Externally Leveled ..............
2-3
2-2. Typical Diode Detector Response at 25 “C .........
2-5
2-3. Leveling with a Power Meter ...............
2-7
2-4. Millimeter-wave Source Module Leveling ..........
2-9
2-5. Millimeter-wave Source Module Leveling Using a Microwave
Ampliher ......................
2-10
4-1. Millimeter-wave Source Module Leveling ..........
4-4
4-2. Millimeter-wave Source Module Leveling Using a Microwave
Amplifier ......................
4-6
5-1. Creating a User Flatness Array ......... .....
5-3
5-2. Scalar Measurement System Setup ............
5-6
6-l. Master/Slave Setup ...................
6-3
7-l. Sweeper Connectors - Front Panel .............
7-3
7-2. Sweeper Connectors - Rear Panel .............
7-4
7-3. Auxiliary Interface Connector ...............
7-8
7-4. HP-B Connector and Cable ................
7-10
7-5. Interface Signals of the Source Module Connector ......
7-13
7-6. Sweeper Display ............... .....
7-16
7-7. Sweeper Display and LED Annunciators ..........
7-19
7-8. HP-B Address Switch Settings ..............
7-23
7-9. Instrument Language Switch Settings ...........
7-24
7-10. Clear Register Contents Settings .............
7-24
7-l 1. The Sweeper Line POWER Switch .............
7-27
7-12. Power Cable and Line (Mains) Plug Part Numbers ......
7-30
8-l. Instrument State Group .................
8-2
9-l. The Markers Group ...................
9-2
10-l. The Modulation Group ...................
10-2
11-l. The Frequency Group ..................
11-2
12-1. The Sweep Group ....................
12-2
13-1. The Power Group ....................
13-2
14-1. The Entry Group ....................
14-2
15-1. The Instrument Group ..................
15-2
17-l. Typical Swept Frequency Accuracy (100 ms sweep, ramp
mode) .......................
17-6
17-2. Typical Maximum Available Power ............
17-7
Contents-7