I
-
I
-
Error Messages
SCPI Error Messages
-214
-215
-220
-221
-222
-223
-224
-225
“Trigger deadlock”
Indicates that the trigger source for the initiation of a measurement
is set to GET and subsequent measurement query is received. The
measurement cannot be started until a GET is received, but the
GET would cause an INTERRUPTED error.
“Arm deadlock”
Indicates that the arm source for the initiation of a measurement is
set to GET and subsequent measurement query is received. The
measurement cannot be started until a GET is received, but the
GET would cause an INTERRUPTED error.
“Parameter error”
Indicates that a program data element related error occurred. This
error message 0 should be used when the device cannot detect the
more specific errors described for errors -221 through
-229.
“Settings
contlict”
Indicates that a legal program data element was parsed but could
not be executed due to the current device state. (See IEEE 488.2,
6.4.5.3 and 11.5.1.1.5).
“Data out of range”
Indicates that a legal program data element was parsed but could
not be executed because the interpreted value was outside the
legal range as deEned by the device. (See IEEE 488.2, 11.5.1.1.5).
“Too much data”
Indicates that a legal program data element of block, expression,
or string type was received that contained more data than the
device could handle due to memory or related device-speciEc
requirements.
Illegal parameter value
Used where exact value, from a list of possibilities, was expected.
Out of memory.
The device has insufficient memory to perform the requested
operation.
16-15
To Next Page
Loading...
General