I
-
I
-
Performing the Operator’s Check
The operator’s check consists of a series of tasks that, when completed, will
either assure you that your instrument is operating correctly, or will help
to point to problem areas if it is not. The operator’s check
does
not ensure
performance to specifications.
The operator’s check should be performed on a weekly basis, or whenever
the integrity of the sweeper is in question.
To perform the operator’s check, the following tasks should be performed, in
order:
1. Run the full self-test.
2. Run peak power-tracking.
3. Check the maximum leveled power.
4. Check the output power.
l-2
To Next Page
Loading...
General