HP A5800 Series Installation Guide

3
Table 4 Limits on harmful gases in the equipment room
Gas
Maximum concentration (mg/m
3
)
SO
2
0.2
H
2
S
0.06
NH
3
0.05
Cl
2
0.01
Rack-mounting requirements
Before rack-mounting a switch, make sure the rack meets the following requirements:
 HP recommends that you mount a switch in an open rack. If you mount a switch in a closed rack,
make sure there is a good heat dissipation system.
 Make sure the rack is steady enough to support the switch and accessories.
 Make sure that the switch fits the rack size. Leave some spaces beside the left and right panels of the
switch for chassis heat dissipation.
Installation tools
 Flat-blade screwdriver
 Phillips screwdriver
 ESD-preventive wrist strap
All these installation tools are user supplied.

HP A5800 Series Specifications

General

Brand	HP
Model	A5800 Series
Category	Switch
Language	English