HP A5830 Series User Manual

55
# Configure bbb as the default ISP domain for all users. Then, if a user enters a username without any
ISP domain at login, the authentication and accounting methods of the default domain are used for the
user.
[Switch] domain default enable bbb
• Configure 802.1X authentication.
# Enable 802.1X globally.
[Switch] dot1x
# Enable 802.1X for port GigabitEthernet 1/0/1.
[Switch] interface gigabitethernet 1/0/1
[Switch-GigabitEthernet1/0/1] dot1x
[Switch-GigabitEthernet1/0/1] quit
# Configure the access control method. (Optional. The default setting meets the requirement.)
[Switch] dot1x port-method macbased interface gigabitethernet 1/0/1
3. Verify the configuration.
If the 802.1X client of Windows XP is used, the properties of the 802.1X connection should be
specifically configured in the Authentication tab on the Properties page, where you must select the
Enable IEEE 802.1X authentication for this network option and specify the EAP type as MD5-Challenge.
If the HP iNode client is used, no advanced authentication options need to be enabled.
When using the HP iNode client, the user can pass authentication after entering username dot1x@bbb
and the correct password in the client property page. When using the Windows XP 802.1X client, the
user can pass authentication after entering the correct username and password in the pop-up
authentication page. After the user passes authentication, the server assigns the port connecting the
client to VLAN 4.
# Use the display connection command to view the connection information on the switch.
[Switch] display connection
Slot: 1
Index=22 , Username=dot1x@bbb
IP=192.168.1.58
IPv6=N/A
MAC=0015-e9a6-7cfe
Total 1 connection(s) matched on slot 1.
Total 1 connection(s) matched.
# View the information of the specified connection on the switch.
[Switch] display connection ucibindex 22
Slot: 1
Index=22 , Username=dot1x@bbb
IP=192.168.1.58
IPv6=N/A
MAC=0015-e9a6-7cfe
Access=8021X ,AuthMethod=CHAP
Port Type=Ethernet,Port Name=GigabitEthernet1/0/1
Initial VLAN=2, Authorization VLAN=4
ACL Group=Disable
User Profile=N/A
CAR=Disable
Priority=Disable

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English