HP A6616 - Page 26

FIP-110
Introduction
The FIP-110 supports MIMs only. It provides high-density narrowband aggregation, and hence
can protect legacy investment. The FIP-110 supports four MIMs at the same time.
Figure 1-17 Front view of the FIP-110
(1) Slot 1 (2) Slot 2
(3) Slot 3 (4) Slot 4
(5) OPEN BOOK sign (6) Combo interface 0
(7) Combo interface 1
"OPEN BOOK" sign – Refer to related sections when performing the following operations:
Operation Reference
Plug/unplug a FIP-110 “Installing and Removing a FIP” in Chapter 4 “Installing the Router”
Plug/unplug a MIM “Installing and Removing a MIM” in Chapter 4 “Installing the Router”
Connect an Ethernet cable
“Connecting the Management Ethernet Interface” and “Connecting
Ethernet Cables” in Chapter 4 “Installing the Router”
Plug/unplug an optical fiber
“Connecting an optical Ethernet interface” in Chapter 4 “Installing the
Router”
Technical specifications
Table 1-20 Technical specifications for the FIP-110
Item Specification
Processor MIPS 1 GHz
Processor cores 2
Flash 4 MB
Memory type and size
DDR2 SDRAM
1 GB (default, one 1 GB memory module)
2 GB (maximum)
NVRAM 128 KB
Combo interfaces
2
2 electrical interfaces
(automatic MDI/MDIX)
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
2 optical interfaces 1000 Mbps, full-duplex
HIM Not supported