EasyManua.ls Logo

HP Brio BA600 - Removing and Replacing the Cover

HP Brio BA600
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
Removing and Replacing the Cover
Removing and Replacing the Cover
Removing the Cover
1
Place the PC on a flat surface and stand behind it.
2
Disconnect all cables from the rear of the PC.
3
Loosen the three thumb screws from the rear of the PC.
4
Slide the cover back by about 1cm (0.3 inches).
5
Pulling the bottom edges of the cover apart slightly, lift it up and off the PC.
Caution
For your safety, disconnect the power cord and all external cables.

Table of Contents

Other manuals for HP Brio BA600

Related product manuals